PLPFF-PP Series large surface area 3 layers Polypropylene Pleated filter, best of both surface and depth filtration

TrioPro^® Series Polypropylene Pleated Filter Cartridge

TrioPro^® is the choice for wide range of application and comes with wide range of standard package that fits majority of standard industrial filter housing. The cartridge comes in with standard retention rating of between 0.2 and 60 micron, is a high performance pleated filter cartridge with very large filter area (typically 0.6~0.7m² for every 10" in filter length), the filter material is constructed of melt-blown polypropylene micro-denier fiber media and its three layer design including a coarser inner and outer supporting filter membrane resulted in very good mechanical properties for the filter.

TrioPro^® Suitable Application

	Terminal Polished Filtration for ultra-pure Water (deionized water) system
	Filtration of solvents for display, semiconductor, electronic industries such as CD, DVD manufacturing
	Perfectly safe for beverage process including beer, soft drinks and mineral water systems
	Filtration of low to medium viscosity chemical including photographic processing
	Final Polished filtration for medical and pharmaceutical application
	High purity chemical liquid filtration

TrioPro^® Advantage

	100% polypropylene material for good Chemical compatibility with wide range of chemicals
	Pleated design with more filter area for increased contaminant level, high flow rate and less pressure drop
	Pre-flush with 18 M ohm-cm DI water for fast rinse up of de-ionized water, TOC content is lower than 40ppb
	Entire construction including end caps and inner core are thermally bonded together and free of binder agents.
	Integrity test available upon request
	End cap configuration to fit most industrial housings

Product Specifications

Micron Ratings

0.2, 0.45, 1, 3, 5, 10, 30, 60 µm Absolute

Standard Dimensions

Inner Diameter: 28mm

Outer Diameter: 69mm

Length: 127mm, 254mm, 508mm, 762mm, 1016mm

Effective Filter area: 0.60 ~ 0.70 m² per 254mm in filter length

Media of membrane

100% pure melt blown micro-denier polypropylene fiber

Inner and outer core

High strength Polypropylene

Gasket and O ring Materials

Buna N, Silicone, Viton

Maximum Differential Pressure

0.42 MPa @ 25ºC; 0.28 MPa @ 60ºC

Maximum Operating Temperature

88 ºC @ 0.28 MPa; 60ºC @ 0.42 MPa

Maximum Sterilizing Temperature

Dry Sterilizing Cabinet 120ºC, 0.1 MPag; Steam Sterilizing Cabinet 134ºC, 30 minutes

Water Flowrate Specifications

See Chart on the right for 10 inch cartridge

Material Toxicity

FDA approved materials for food and beverage direct contact

Filter Construction

The three layers structure and high surface area of the TrioPro series filter enable both longer service filter life, high flow rate and small pressure drop without risk of filter collapse. The series offer wide range of endcap configuration as shown below for all standard industrial housing. Length of filter available for upto 40 inch.
Type No. A	Type No. B	Type No. C	Type No. D

Double plate open OD69mm ID 28mm	Double plate seal OD 69mm ID 28mm	222 O-ring /end cap OD: 44.5mm	222 O-ring/stainless steel OD: 44.5mm

Type No. E	Type No. F	Type No. G	Type No. H

226 O-ring / end cap OD: 57mm (Two O-ring with fin)	226 O-ring / stainless steel OD: 57mm (Two O-ring with fin)	223O-ring / end cap OD: 44.5mm (Two O-ring with three fin)	Spear End Cap (Fin)